Site Overlay


This is a Kenwood VHF repeater, model number TKR This is a 32 ch, 50 watt repeater that operates in the Mhz range. Repeater is capable of both. Find great deals for Kenwood Tkr Repeater VHF 16ch MHz 50 Watts. Shop with confidence on eBay!. TKR) TCXO modules, % duty RF power amplifier output is 50W (at 50 % duty) a TKR is 40W (at. 50% duty). make Kenwood’s TKR/

Author: Yozshull Mazshura
Country: Italy
Language: English (Spanish)
Genre: Software
Published (Last): 12 October 2005
Pages: 253
PDF File Size: 1.74 Mb
ePub File Size: 7.24 Mb
ISBN: 971-8-29424-402-7
Downloads: 64753
Price: Free* [*Free Regsitration Required]
Uploader: Sharn

Incompatible with W amplifier option. Then we bought 2 more kenwooe replace our aging Aerotrons. If you have any questions, problems, or suggestions about Reviews, please email your Reviews Manager.

In the front part of the rec there are 5 coils you have to tune with a signal gen. We’ve had the pre amps and TRK’s in service about 2 years with no issues. The only negative thing I found was that hkr-750 audio level on the discriminator is extremely low.

Then I retuned the coils and got it down to.

The rec goes down to. New to Ham Radio?

Just asking for it to be blown out as I’ve seen time and time again. I agree the comment about purchasing the Kenwood TKR instead of building a repeater from parts. I have program’d all 3. We use these repeaters in commercial radio sites. The Kenwood software is excellent. Audio is fantastic, and it is easy to implement an external controller or accessory. These have a built in DTMF controller, which can be configured to control internal functions, or drive external accessories or relays.


For use with voting systems, supplies Ohm balanced 2-wire audio, occupies 1 RU. Built in mini controller is nice. The suggested KPS switching power tkr–750 is a toaster.

May not be the best out there but, they get the job done for kenwoid. Email Subscription You are not subscribed to this review. I wouldn’t put a pre amp up near an antenna for love or money. Audio is really good also. Price is very reasonable, and would buy one again. Excellent performance, even with less than optimal filtration They seem as reliable. We had trouble with a out board controller and switched to the ktr-750 one without loss of service.

Kenwood rates them at 25 watts continuous, and that seems accurate. The only thing I can fault the Kenwood’s on is that the audio could pass a little more bass.

Base Station & Repeater

Modem bps to be used with LTR controllers, includes interface cable. We have 2 others as stand alone repeaters, and 2 of the TKR Programmed repeater the on the bench and installed on site it has worked great without any changes.


Cabinet Solid Floor Panel. Only one weak point: Patent and other rights reserved. When I was done programing the repeater I checked the rec and it was 1. And yes, I checked the alignment and it was correct.

TKRE – (Discontinued) — Kenwood South Africa

They have been in use daily for years now and never miss a beat. As for sensitivty I was disappointed.

I wound up using an Angle Linear GasFet preamp and a preselector to get it back up where it needed to be. I had to modify the CAT to get the audio up to where it should be. As others have noted, about the only alignment required is the helical front end in the RX. Plus why amplify noise before the duplexers? The 25 pin connector gives you everything you need. Includes equipment installation, hardware, cabling and wire management materials, and cushioned shipping crate.

Signal-to-Noise Modular Voting Comparator. Includes five pre-drilled openings and grommets. Could use a little more kenwokd, but we have never had one go down.